Anti Rattle or Window Seal kit Installation Question

[lightfoot]

How do you install the window seal kit on a 1968 f100? I have the LMC kit, part number 49-7115. I removed the armrest, window handle, door handle and the metal access panel but stopped there. It looks like I have to drop the window, but I'm not to sure how to do that. Any tips or suggestions will be appreciated.
Thanks.

[jimmy828]

To get the window out you will have to remove the screws from the vent window which are 3 located on the outer edge of door frame and 1 below the vent window. You will also find a small bolt at the bottom of front window channel . Just take your fingers a follow the channel to bottom, you will find it. I found it was easier to try to install the vent window and larger window at the same time. Once you get the vent window bolts/screws loose you i think you will figure it out from there. Good luck

[Mach428]

You may wish to look at the bottom of the window when it is fully down to see if there is a stop that can be removed so that the window goes a bit lower. You only need the window out of the way of the anti-rattle part just a bit in order to remove and reinstall the new one.

[71StylesideF100]

This one's on my list too.... please post a follow once installed.