1968-72 FACTORY A/C DRAIN HOSE LOCATION?

CHUCK4850 · Post by **CHUCK4850** » Wed Jan 07, 2015 9:25 am

I'm installing a 1968-72 factory A/C unit in my truck, and I need to drill a hole in the floor for the condensation drain hose. Does anybody have a truck that originally came with A/C that can check the location? I'm thinking there is probably a dimple where the floor should be drilled, but my floor is covered with Dynamat and bedliner, so I can't see it.
Chuck

fordman · Post by **fordman** » Sat Jan 10, 2015 1:02 pm

http://www.fordification.com/images/for ... ewall3.jpg

http://www.fordification.com/images/for ... ewall2.jpg

Hope that helps.

CHUCK4850 · Post by **CHUCK4850** » Wed Jan 14, 2015 4:28 pm

Thanks!

2wdwyatte · Post by **2wdwyatte** » Fri Jan 16, 2015 9:14 pm

Since you say that there is dynamat on the inside, check the firewall from the engine compartment and there should be bump or dimple (raised) on the fire wall for the a/c hoses and on the front side of the driver side radiator support for the receiver/drier and condensor hoses. I can't remember if there is one for the drain hose. But once you install the factory underdash unit you can easily orientate where to drill.

The FORDification.com Forums

1968-72 FACTORY A/C DRAIN HOSE LOCATION?

1968-72 FACTORY A/C DRAIN HOSE LOCATION?

Re: 1968-72 FACTORY A/C DRAIN HOSE LOCATION?

Re: 1968-72 FACTORY A/C DRAIN HOSE LOCATION?

Re: 1968-72 FACTORY A/C DRAIN HOSE LOCATION?